Normal, IL
What we run into on Normal floors
Normal splits three ways for us. Around Illinois State University and Uptown, there is a steady stream of rental, retail and small-commercial floors where the priority is a fast turnaround between tenants and a surface that mops clean rather than one that looks like a showpiece. Old North Normal and the streets around Fairview Park run to older homes with detached garages on aging concrete. Out on the north side, Blackstone Trails, Savannah Green and the newer subdivisions off Raab Road bring large attached three-car garages on modern slabs, and those are where most of our residential flake work in Normal happens. There is also real industrial square footage in and around town — the manufacturing corridor here keeps heavier work in the mix, which means a different system, a heavier build thickness and shot blasting rather than grinding, but the same prep discipline underneath it.
Garages
Garage Floor Coating in Normal, IL
Garage floor coating in Normal is mostly newer-subdivision work, and on a clean modern slab the install is quick: grind, treat the joints, base coat, broadcast flake, scrape and vacuum, clear topcoat. One to two days on site. Around Old North Normal and the older streets it is the familiar mid-century slab that needs crack and apron repair first. One thing worth knowing if you are near campus: we can schedule around the university calendar, which matters if you are coating a rental garage or a small commercial floor and need it done between tenants rather than during a move-in week.
Epoxy floor quote in Normal?
(217) 417-5950Call and tell us the room. We cover McLean County with no trip charge, and we can usually say on the phone roughly what your slab will need.
Prefer to type it out? Send the quote form instead or email dpflooringservicesllc@gmail.com.
Service area
Where Normal sits in our range
Same run as Bloomington, straight up I-74. Uptown Normal, ISU, Constitution Trail and the north side are all inside the no-trip-charge area.
We are based in Champaign County and work 50+ miles in every direction, so Normal and the rest of McLean County are well inside it, along with Bloomington, Hudson, Towanda, Le Roy.
Call (217) 417-5950 and we will tell you straight away when we can get out to look at it.
Map shows the Normal, IL area we cover.
Services
What we install in Normal
All six services are available across McLean County and the surrounding towns.
Nearby
Other towns we cover
- Epoxy Flooring in Champaign, IL
- Epoxy Flooring in Urbana, IL
- Epoxy Flooring in Savoy, IL
- Epoxy Flooring in Mahomet, IL
- Epoxy Flooring in Rantoul, IL
- Epoxy Flooring in Bloomington, IL
- Epoxy Flooring in Decatur, IL
- Epoxy Flooring in Danville, IL
- Epoxy Flooring in Monticello, IL
- Epoxy Flooring in Tuscola, IL
- Epoxy Flooring in Paxton, IL
- Epoxy Flooring in Clinton, IL
- Epoxy Flooring in Tolono, IL
Questions
Before you book a Normal quote
How long does epoxy take to cure?
Most floors are ready for light foot traffic about 12 to 24 hours after the final coat, furniture and light use at 24 to 72 hours, and vehicle traffic after roughly 5 to 7 days. Full chemical cure takes about a week.
Those windows move with temperature and humidity, so we give you the exact dates for your floor before we start. And we would much rather tell you to wait two extra days than watch tire marks press permanently into a coating that was still green.
How long does an epoxy floor last?
A properly prepped residential garage or basement floor commonly runs 10 to 20 years. Commercial and industrial floors under forklifts, steel wheels and constant traffic are usually in the 5 to 10 year range before they want a recoat — and a recoat is far cheaper than a new install, because the prep is already done.
The single biggest factor is not the epoxy. It is the surface prep underneath it. That is exactly why we grind every floor instead of acid-etching it and hoping for the best.
Can you put epoxy over an existing floor?
Over bare concrete — yes. That is the ideal surface, and we grind it first to open the pores so the coating can key into it.
Over an existing coating — it depends. If the old coating is sound and well bonded, we can abrade it and go over the top. If it is peeling, chipping, bubbling or flaking, it has to come off first — and we do that too.
Over tile, wood, vinyl or carpet — no. Epoxy needs concrete to bond to, so those have to be removed first. We will tell you which situation you are in at the estimate, before you have committed to anything.
How much does epoxy flooring cost?
Epoxy is priced by the square foot, and four things move the number:
- Square footage. Bigger floors cost less per foot — the setup is the same whether the room is 400 or 4,000 square feet.
- Slab condition. A clean, sound slab needs a grind. One with cracks, spalling, pits or an old failing coating needs repair work first.
- The system you pick. Solid color is the most economical, full flake sits in the middle, and metallic is the premium option.
- Extras. Non-slip aggregate, line striping, cove base and heavier build thicknesses all add to it.
We will not quote a floor we have not seen, because a number pulled over the phone helps nobody. Call (217) 417-5950 and we will come measure. The estimate is free, itemized and in writing, so you can see exactly what you are paying for.
Get a free Normal quote
On-site, itemized and in writing — with no trip charge anywhere in McLean County.